pro
pro
You are here: Home / Products / ASK Module / 433MHz RF Receiving Module with Switch Control And Learning Code Function

Product Detail

Share to:

433MHz RF Receiving Module with Switch Control And Learning Code Function

433MHz Wireless Switch Control Module with Compact Size, and High Sensitivity.

  • DL-RX06C
  • 433/315 MHz
  • RF Receive Chip
  • -1dBm
  • 3~5V
  • -112dBm
  • 300m
  • 24.5*12.8*2mm
Quantity:

433MHz RF Receiver Module with Switch Control and Learning Code Function


DL-RX06C is a compact size super heterodyne wireless receiving module with decoding (learning code) function, it is very low power consumption, but high sensitivity. It uses a cost-effective wireless receiving chip and a low power consumption MCU. Its performance indicators and functions are similar to another RF receiving module DL-RX809L, but N3 pair of code keys are added, as well as another N4 pair of ports (for LEDs indicate), so you can lead code keys and relative LEDs to your own product (on the circuit board or housing) for your convenience. 

DL-RX06C pins are changed into 2.0 spacing, which reduces the size of the module. With double-sided direct insert pads, you can make slot pads on your own circuit board, insert the module directly on the circuit board and use wave soldering. The module height will be only 10cm after welding. 

DL-RX06C is compatible with PT2262 and 1527 encoding, which has a lock and non-lock selection port, four-channels switching value output, decodes high level output, you can directly replace the original decoding chip scheme to reduce product cost and reduce product volume. At the same time, the module has a low power mode selection port, and receives the lowest average power consumption of 80 microamps. You can use 3-5V power supply.


Applications

● Multi- channel controller for electric vehicles

● Multi- channel input and output switching control

● Remote control of multi-channel chandelier and lighting

● Wireless multi-channel opening and closing controller

● Standard 1527 protocol remote control

● Energy control and management

● Multi- level control circuit&nbsp

● D1-D4 can directly drive Darlington and relay circuits

● Intelligent buildings

● Multi- channel on-off control of motors


Features

● Frequency range: 315MHz, 433.92MHz (special frequency can be customized)

● Sensitivity: Up to -112 dBm

● Power supply voltage input range: 3V-5V (recommended working voltage 3.2V)

● It can be used to learn PT2260, 2262, 1527 remote controllers with good rate compatibility

● Encoded data transmission rate 2.5K bps (Manchester encoding)

● OOK modulation mode, can work with PT4450, 115H, 113, R25 (2SK3356) and other transmitting circuits

● Module size 24.5×13.1×5.6mm

● Modules have good local oscillator radiation suppression capability, multiple receiving modules will not interfere with each other


Download Center

DL-RXC06 Specification V1.0 do


Technical Parameter

Parameter Symbol  State

Reference Value

Min.  Typ.  Max.

Unit
Working frequency Fc
315,433.92 ,— MHz
Modulation Mode

ASK
Receiving sensitivity 
50 ohm antenna direct input /1k Kbps -112 dBm
RF Receive bandwidth 

300  KHz

Data demodulation   bandwidth


Demodulation pulse width is 0.2-1ms

12.5,— K
System Start-up time Ton

ms
Supply Voltage  VDD
33.35.0 V
Working Current IRC VDD=3.3V/315M
mA


VDD=3.3V/433M  3.9
mA
Low power mode current
average value VDD=3.3V/315M mA


VDD=3.3V/315M 300 V
Decode output high voltage
Rl=500k 3,—,5 V
Decode output low voltage

,—,0.3
Working temperature

-20 ~ +60


Pin Definitions

RXC6_01

DL-RXC6 Module interface definition diagram


DL-RXC6 Module interface definition diagram

Pin Description
VDD

Power supply 3-5V

GND  Module grounding,Reliably grounded and close to the system filter capacitor
LED

External code-matching LED indicator, press 2S for code-matching, light on and flashes 3 times

quickly means matching succeed, 8S long press until light off to clear the code

VT Common signal terminal, high level output (signal status indication) when valid signal detected
T1、T2

Working mode setting pins, detailed setting refers to the Logic Truth Table: 11, 10, 01 state

only, 00 state is not used

D1-D4

D0, D1, D2, and D3 correspond to four key values of 1000, 0100, 0010, and 0001 of the standard

remote control respectively

ANT Antenna


DL-RXC6 Module size

RXC6_02

Typical application

Wireless Data Acquisition, Wireless Data Communication, Wireless Data Monitoring and Transmission, Wireless Voice/Audio Transmission, Wireless Sensoring; Wireless Remote Control System; Wireless Game Controller, Remote Control Toys; Wireless Keyboard, Wireless Mouse; Wireless remote control for electronic consumer products; Wireless Alarm & Security Control System; Wireless Sensor Networking, Automatic Data Collection; Industrial Remote Control, Intelligent Control System, Smart Home, Home Automation, Home Appliance Control, Building and Residential (smart home) Control, Smart City, Logistics Tracking, Warehouse Patrols, RFID (radio frequency identification); Telemetry, Automatic (Water, Electricity, Gas) Meter Reading system; Remote LED, Remote Curtain; Remote control that supports radio frequency (RF) technology


Dreamlnk is a high-tech enterprise specializing in ISM band micropower wireless communication technology, providing different kinds of wireless modules and one-stop IoT solutions, including 433/868/915MHz RF transmitter & receiver modules, 2.4G wireless modules, ASK receiving modules, FSK transceiver modules, Bluetooth modules, LoRa modules, UART module, Antennas, Remote Controls, etc. Welcome to inquire!

Search

Get Free Samples

One-stop IOT Solution Provider

QUICK LINKS

PRODUCT CATEGORY

CONTACT US

  Add.Room 603, Unit C, Zone A,    Huameiju Business Center, Xinhu Rd., Bao'an District, Shenzhen, China
  Phone: +86-755-29369047
  WhatsApp: +86 13760215716
  Skype: wsj.james
 
WeChat: wsj_james
  E-mail: james@dreamlnk.com

Copyright  2020 SHENZHEN DREAMLNK TECHNOLOGY CO., LTD. All Rights Reserve| SITEMAP