DL-LLCC68-S RF module has high receiving sensitivity of -129dBm@LoRa, ultra-low receiving current and dormant current, the transmit power can be configured through software, and the maximum power can reach +22dBm. Compared with traditional modulation technology, LoRa™ modulation technology has obvious advantages in anti-blocking and selection, which solves the problem of distance, anti-interference and power consumption that traditional design schemes cannot take into account at the same time.

This DL-CC1310-B Wireless Module supports Narrow-band Communication, Direct Sequence Spread Spectrum (DSSS), Long-range Transmission and High-efficiency Communication. Its fully functional AT Commands support any Serial Baud Rate setting from 1920bps to 256000bps, which can greatly improve the communication efficiency with up to -124dBm receiver sensitivity.

DL-SX1278PA is a high power 433Mhz LoRa Transceiver Module, which was developed based on Semtech's RF chip SX1278. For long-range transmission and better coverage concern, a power amplifier (PA) and a low noise amplifier (LNA) are integrated into this LoRa module, which makes its output power up to 30dBm (1W) and receiving sensitivity up to -149dBm

This DL-P3028MPA RF module is a high-power UART Transceiver Module with PA, it was designed base on PAN3028 high-performance RF chip and built-in HC32L130 low-power MCU. It is an UART Module with AT command, which supports a maximum power output of 32dBm and a sensitivity of -140dBm; it is an effective wireless module which can provide excellent RF performance and strong anti-interference performance in the 398-510MHz frequency band.

M-SX1278S2 LoRa module with Semtech’s SX1278 chip, it is a 433Mhz LoRa Wireless Module with 3KM long range and 100mW output power.

M-BK2461U 2.4G RF Module is a low-power, high-bandwidth wireless UART module operating in 2.4GHz ISM band. It adopts Beken BK2461 chip and serial port design, U-UART interface and 121 multi-channels development-free, which can be widely used in daily life where wireless connection is required.